Access Tile Cast in Place Installation Video

Steps

	Maintaining a 4-7 slump range, pour and float the cement.
	Without removing any cement, place the tile on the curb ramp 6"-8" from the curb line (face of curb).
	Tamp the tile in grid pattern across the top face, embedding the tile into the cement using a non-marring rubber mallet.
	Create an edge around the perimeter of the tile using a 3/8" radius edging tool then float the concrete around the tile's perimeter using a steel trowel.
	Apply a broom-finish to the curb ramp.
	After the concrete has substantially cured, remove the protective plastic wrap by cutting the plastic with a sharp knife tight to the concrete/tile interface.